UltraTileFix ProPrimer (10x 1Ltr bottles)

£105.00 inc VAT

UltraTileFix ProPrimer provides improved bond strength on multiple substrates, ideal for walls & floors it’s designed for porous & non-porous substrates. Available in a pack of 10 x 1 Litre Bottles

SKU: PROPRIMER1 Categories: , ,

Description

UltraTileFix ProPrimer

UltraTileFix ProPrimer is a polymer primer that provides an exceptional bond to multiple floor & wall substrates and is designed for both porous and non-porous substrates. UltraTileFix ProPrimer is ideal for concrete, sand & cement screed, plywood overlay (15mm min), tile backer boards, cement-faced fibre boards, anhydrite screeds, tile on tile, plaster, plasterboard, sand & cement render, concrete brick/block, hard vinyl tiles, and flooring grade asphalt.

Technical Data:

  • 10 x 1L Bottle
  • Dries Clear
  • Coverage: 1:1 Dilution 14-20m², 3:1 Dilution 28-40m²
  • Neat: 5-10m²
  • Application Temperatures: 5˚C to 25˚C

Surface Preparation:
Ensure the area is thoroughly dry, free from any contaminant that may hinder adhesion such as dust, oil and grease and in a sound stable condition. Prior surface treatments must be removed and the surface roughened by mechanical scabbing to provide a good key.  If using with underfloor heating this must be switched off for at least 48 hours before and after the application. If you apply Ultra Tile Fix ProPrimer onto a calcium sulphate screed it must be dry and below 75%RH. Calcium sulphate screeds are prone to surface laitance and should be mechanically abraded to remove any debris on the surface.

Application:
Apply UltraTileFix ProPrimer using a brush or roller, scrub well into the surface to avoid any pooling and allow to fully dry. If you need to apply a multi-coat, ensure each that each coat dries before you apply the next.

Porous Substrates:
UltraTileFix ProPrimer should be diluted before use. The for a 1st coat use 3 parts water to 1 part primer, for a 2nd coat use 1 part water to 1 part primer. On really absorbent subfloors you will almost certainly require a 3rd coat, if a 3rd coat is needed use this at 1 part water to 1 part primer. In good drying conditions, UltraTileFix ProPrimer should be ready for an additional coats after approximately 1-2 hours.

Non-Porous Substrates:
On non-porous substrates use just 1 coat, completely neat.

Additional information

Weight 10 kg

Reviews

There are no reviews yet.

Be the first to review “UltraTileFix ProPrimer (10x 1Ltr bottles)”

Your email address will not be published. Required fields are marked *