UltraScape SlipBond: Vertical Stone and Brick Slip Adhesive
SlipBond is a flexible cladding adhesive for both internal and external use. Slipbond consists of blended cements, graded fillers and additives and a high level of redispersible powder polymer. It is specially formulated with extended workability for fixing brick slips and natural stone to a range of substrates including sand/cement render, brick and block work and can be used for wall and floor applications as well as with external and internal wall installation systems.
- Ideal for use in all weathers
- Applied to a thickness of 3mm – 20mm
- Frost resistant
- Suitable for: brick slips and natural stone
- Can be used with external wall installation systems
- Extended workability
- Suitable for underfloor heating
- External / internal use
- 20kg paper bag
- Coverage – 5m2 at 3mm depth
UltraScape SlipBond is a flexible cladding adhesive for both external & internal floor and wall applications. It’s made of a blend of cements, graded fillers and additives with a high level of re-dispersible powder polymer. Slipond Cladding Adhesive is specially designed with extended workability for fixing brick slips and natural stone to a range of substrates including sand/cement render, brick and block work and it can be used with external wall installation systems.
UltraScape SlipBond comes in a 20Kg reinforced paper bag, is a pre-mixed dry-pack which only requires the addition of water on-site. Slipbond can be applied to a thickness of 3mm – 20mm up to 1m2 at a time.
How to prepare surfaces
Care must be taken to remove all loose material, debris, dirt, grease, paint and efflorescence from the wall or floor surface prior to applying the cladding adhesive. The concrete, masonry, wall substrate should be thoroughly dampened with water. Any surplus water should be removed prior to starting the application of Slipbond.
How to mix Slipbond
UltraScape SlipBond should be added slowly to 5.2 litres of clean water per 20kg bag and mixed thoroughly. Ideally Slipbond should be mixed with a forced action mixer, for 3 minutes to give a slump free, smooth texture. Once mixed the mortar is immediately ready for use and has a pot life of approximately 2 hours at 20°C. It is important to only mix sufficient adhesive to be used within the pot life, do not remix or re-wet.
How to apply Slipbond
Use a trowel to apply a layer of mortar onto the substrate with sufficient force to ensure a good bond. On large format stone it is advisable to back butter the stone slabs or tiles prior to bedding. Once you have applied the mortar bed, ensure that the stone is applied within 25 minutes. Tools should be cleaned in water immediately after use to remove excess materials.
For info call ☎️ 0845 862 1099